Read Command
AT+QJDR?
Write Command
AT+QJDR=<mode>
Parameters
<mode>
Disable or enable the jamming detection function
0
Jamming Detection function is disabled (default is 0)
1
Jamming Detection function is enabled
About URC description, please refer to Chapter 3.3
3.3. URC Description
3.3.1. Disturbed Indicator
If the module detects a Jammer, it will send the URC "+QJDR: JAMMED" to the serial port.
Indication of Jammer Presence
+QJDR: JAMMED
3.3.2. Jammer Removal Indicator
If the Jammer was removed then it will send the message "+QJDR: NOJAMMING" to the serial port.
Indication of Jammer Removal
+QJDR: NOJAMMING
WCDMA_Jamming_Detection_Application_Note
WCDMA Jamming Detection Application Note
Response
If <mode> was set to "1" which means enable the
jamming detection function, return:
+QJDR: NOJAMMING
or
+QJDR: JAMMED
OK
If <mode> was set to "0" which means disable the
jamming detection function, return:
+QJDR: 0
OK
Response
OK
ERROR
Confidential / Released
UMTS/HSPA Module Series
9 / 13
Need help?
Do you have a question about the WCDMA and is the answer not in the manual?