Table of Contents
Advertisement
Troubleshooting
Problem:
The 2-Way Dimmer will not operate the lights and the LEDs on
the Dimmer do not light up.
Solution:
Firstly, check that there is power to the dimmer. Make sure that
the connected lamps (bulbs) are functioning correctly; the dimmer switch
will not run unless it has a functioning lamp/s to complete the circuit.
Ensure that the maximum LED/incandescent loading has not been
exceeded (if so this may have damaged the dimmer). Check that the wiring
is correct; it is important that the live, switched live and signal wires are
attached to the correct terminals; a common mistake is to reverse the live
and switched live connections. Remember, the signal terminal must NOT be
connected to 230V mains. If these measures fail, contact technical support
via www.Lightwaverf.com.
Problem:
The 2-Way Dimmer has power (LEDs on) but will not turn on the
Lights/turns on then o
by itself/ will not operate from the other dimmer.
Solution:
Check that the wiring is correct; it is important that the live,
switched live and signal wires are attached to the correct terminals; a
common mistake is to reverse the live and switch live connections which
may cause the 2-Way Dimmer to function improperly. Remember, the signal
terminal must NOT be connected to 230V mains. If these measures fail,
contact technical support via www.lightwaverf.com.
Advertisement
Table of Contents
