Step 4: Verifying Proper Power Optimiser Connection - SolarEdge SE15K-AU Installation Manual

4. If you intend to monitor the installation, using the SolarEdge Monitoring platform,
record the physical location of each Power Optimiser, as described in Creating
Logical and Physical Layout using Installation Information on page 52.

Step 4: Verifying Proper Power Optimiser Connection

When a module is connected to a Power Optimiser, the Power Optimiser outputs a safe
voltage of 1V (±0.1V). Therefore, the total string voltage should equal 1V times the
number of Power Optimisers connected in series in the string. For example, if 10 Power
Optimisers are connected in a string, then 10V should be produced.
Make sure the PV modules are exposed to sunlight during this process. The Power
Optimiser will only turn ON if the PV module provides at least 2W.
In SolarEdge systems, due to the introduction of Power Optimisers between the PV
modules and the inverter, the short circuit current I
hold different meanings from those in traditional systems.
For more information about the SolarEdge system's string voltage and
current, refer to the V
available on the SolarEdge website at:
https://www.solaredge.com/sites/default/files/isc_and_voc_in_solaredge_
sytems_technical_note.pdf
To verify proper Power Optimiser connection:
Measure the voltage of each string individually before connecting it to the other
strings or to the inverter. Verify correct polarity by measuring the string polarity with
a voltmeter. Use a voltmeter with at least 0.1V measurement accuracy.
NOTE
Since the inverter is not yet operating, you may measure the string Voltage
and verify correct polarity on the DC wires inside the DC Safety Unit.
Three Phase Inverter with SetApp Configuration
Figure 4: Power Optimisers connected in series
and I in SolarEdge Systems Technical Note ,
OC SC
Chapter 2: Installing the Power Optimisers
and the open circuit voltage V
SC
18
OC