Table of Contents
Advertisement
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and unplugged before carrying out
any work on the tool.
Removing or installing diamond
wheel (optional accessory)
CAUTION:
Always be sure that the tool is
switched off and unplugged before installing or
removing the diamond wheel.
CAUTION:
BE SURE TO TIGHTEN THE HEX
BOLT SECURELY. Also be careful not to tighten
the bolt forcibly. Slipping your hand from the hex
wrench can cause a personal injury.
CAUTION:
Use only the Makita wrench and
hex wrench to install or remove the wheel.
To remove the diamond wheel, hold the outer flange
with the wrench and turn the hex bolt clockwise with the
hex wrench. Then remove the hex bolt, outer flange and
diamond wheel.
1
2
► 1 . Wrench 2. Hex wrench 3. Diamond wheel
To install the wheel, follow the removal procedure in
reverse. Always install the wheel so that the arrow on
the diamond wheel points in the same direction as the
arrow on the blade case. Be sure to tighten the hex bolt
counterclockwise securely.
► 1 . Inner flange 2. Diamond wheel 3. Outer flange
4. Hex bolt
Hex wrench storage
► 1 . Hex wrench
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Water flow (Optional accessory)
Only for tool with a water pipe
First, unplug the tool. Loosen the wing bolt on the depth
guide and move the base down. Install the water pipe
on the blade case and secure it by the screw.
Attach the vinyl tube onto the water pipe and attach
the adapter on the vinyl tube to a faucet of water mains
pressure. Adjust the amount of water flow by simply
adjusting the water cock.
3
► 1 . Water cock 2. Wing bolt 3. Water pipe
Only for tool with a vinyl tube
Put the vinyl tube into the tube holder just like screwing
in so that used diamond wheel cannot be obstructed or
interrupted.
1
2
3
4
6 ENGLISH
1
1
2
3
Advertisement
Table of Contents
