Table of Contents
Advertisement
HTTP server configuration
Set the password for logging into the PROJECTOR CONTROL screen. A maximum of up to 10
alphanumeric characters can be set for the password.
PJLink setting
Set the login password for using PJLink. A maximum of up to 32 alphanumeric characters can be set for the pass-
word.
Alert e-mail setting
When using this device connected to a network, computers and other devices will be notified of the status of this
device via e-mail if the lamp of this device is due for replacement, or if an error occurs.
ALERT MAIL
SENDER'S ADDRESS
SMTP SERVER NAME
RECIPIENT'S ADDRESS 1, 2, 3
TEST MAIL
CRESTRON SETTINGS
Configure the settings for connecting this device to a CRESTRON product.
Item
ROOMVIEW
CRESTRON CONTROL
IP address
IP ID
This option will notify your computer of lamp replace time or error messages via
e-mail when using wired LAN.
Placing a checkmark will turn on the Alert Mail feature.
Clearing a checkmark will turn off the Alert Mail feature.
Sample of a message to be sent from the projector:
THE COOLING FAN HAS STOPPED.
[INFORMATION]
PROJECTOR NAME : PJ-XXXXXXXX
LIGHT HOURS USED : XXXX[H]
Enter sender's address.
Enter the SMTP server name to be connected to the projector.
Enter your recipient's address. Up to three addresses can be entered.
Send a test mail to check whether your settings are correct or not.
NOTE:
• If you execute a test, you may not receive an Alert mail. Should this happen, check if
network settings are correct.
• If you entered an incorrect address in a test, you may not receive an Alert mail. Should
this happen, check if the Recipient's Address is correct.
Description
Check this when controlling the unit with a computer.
Check this when controlling the unit with a controller.
Set the IP address of the controller.
Set the IP ID of the controller.
31
7. NETWORK SETTINGS
Advertisement
Table of Contents
