MK Diamond Products 172023-K Owner's Manual & Parts List page 19

EARLY ENTRY CONCRETE SAW
CAUTION
(A)
Use the Raise Lock/Release
Lever to raise the blade clear of
the floor.
NOTE: 1. Ensure the blade you are using is clearly marked for dry cutting.
2. Check the condition of the air filter at least every four hours of operation.
Refer to Engine Manual for details.
WARNING
(D)
Align the pointer and blade with
the cut line and slowly lower the
blade by squeezing the Raise
Lock Release Lever.
Prior to operation of this machine the operator must determine the existence
and location of any subsurface features that may be hazardous or could
damage the equipment, (i.e. electric cable, natural gas line etc...)
Attach the dust collection
system to the vacuum port.
Dry cutting has the potential to expose you to high levels of crystalline silica.
Repeated and/or substantial inhalation can cause serious or fatal respiratory
diseases including silicosis. For more information go to www.P65Warnings.
ca.gov. Employ dust controls and protection per OSHA/NIOSH/MSHA.
Cut with engine at full throttle.
(B)
Start the Saw using the Engine Start
(E)
19
OPERATION
(C)
procedure in the engine manual.
(F)
When the cut is complete, raise
the blade completely out of the
cut by pushing down on the
handlebars until the Raise Lock
engages.