Table of Contents
Advertisement
Display controller operation
5.
5.1 LED wire controller Interface
* When the heat pump is running or on standby, the display shows the water inlet temperature.
* When the heat pump is powered on, the display shows 'OFF'
* Red LED will go on when you turn on the machine.
5.2 Turn on/off the heat pump
Press
to turn on the heat pump, the LED display shows the water setting temperature for 5s, a n d
then shows the water inlet temperature.
Press
again to turn off the heat pump.
NOTE: There is a 3 min time delay at start-up to protect the compressor.
5.3 Set the desired water temperature
Press
or
setting will be saved after 3 seconds.
You can also adjust Parameter d to set the desired water temperature.
NOTE: the heat pump can run only if the water circulation/filtration system is running.
directly to adjust the desired water temperature (parameter d, range:.15—40 ℃), the
- 9 -
Advertisement
Table of Contents
