Majestic MERIDPLA36IN Owner's Manual page 15

- Wait five (5) minutes to allow possible
accumulated gas to clear.
- Set the IFT-ECM 3-position selector switch to ON
or REMOTE position. Module will beep once and
flash a three GREEN LED code on successful
startup.
- If placed in ON position, the appliance will ignite
normally if the error condition was corrected.
- If placed in REMOTE position, use the paired IFT-
RC400, IFT-RC150 or wired wall switch to start
the appliance; appliance will ignite normally if the
error condition was corrected.
- If the IFT-ECM re-enters the lock-out condition
after these steps, call your dealer for service.
Majestic • MERIDPLA36IN, MERIDPLA36IL, MERIDPLA42IN, MERIDPLA42IL Owner's Manual • 2519-981 Rev. E • 1/19
IntelliFire TM Touch Ignition System
NOTICE: Batteries should not be placed in the battery
pack while using the transformer. Remove batteries before
using the transformer, and unplug the transformer before
installing the batteries. Battery polarity must be correct or
module damage will occur.
Appliance ON/OFF:
A wall control, thermostat or remote control may be used
to control the ON/OFF function of the appliance. Follow
instructions included with the installed control.
Heat Management
Optional Heat-Zone ® -Gas Kit
The Heat-Zone ® -Gas heat management option is avail-
able for use with the MERIDPLA36I and MERIDPLA42I
appliances. The Heat-Zone
your fireplace to an adjacent room in your home, up to
20 feet away.
Optional Heat-Out-Gas Kit
The Heat-Out-Gas heat management option is available
for use with the MERIDPLA36I and MERIDPLA42I
appliances and must be used in conjunction with the IFT-
RC400 remote control. The Heat-Out-Gas kit draws heat
from your fireplace and directs it outside, up to 25 feet
away.
Optional Heat-Duct Kit
The Heat-Duct heat management option is available
for use with the MERIDPLA36I and MERIDPLA42I
appliances. The Heat-Duct redistributes heat from the
fireplace via the furnace ductwork.
Optional Fan Kit
If desired, a fan kit may be added. Contact your dealer
to order the correct fan kit. Detailed instructions are in-
cluded with the fan kit.
® -Gas Kit draws heat from
15