Table of Contents
Advertisement
*=Unhook, Unlock, Release, Unplug, or Desolder
e.g. 6(S-1) = six Screws (S-1),
5(L-1) = five Locking Tabs (L-1)
(5): Refer to "Reference Notes."
Reference Notes
CAUTION 1: Locking Tabs (L-1) and (L-2) are fragile.
Be careful not to break them.
1-1. Release five Locking Tabs (L-1).
1-2. Release three Locking Tabs (L-2)
1-3. Disconnect Connector (CN1609), and remove
the Front Assembly.
2. When reassembling, solder wire jumpers as shown
in Fig. D8.
3. Before installing the Deck Assembly, be sure to
place the pin of LD-SW on Main CBA as shown in
Fig. D8. Then, install the Deck Assembly while
aligning the hole of Cam Gear with the pin of LD-
SW, the shaft of Cam Gear with the hole of LD-SW
as shown in Fig. D8.
(S-1)
[1] Top Cover
(S-2)
[3] Front
Bracket
(S-1)
(S-1)
Fig. D1
1-7-2
[4] Radiation Sheet
(S-2)
(L-1)
(L-1)
(L-2)
[5] Jack Bracket
(S-3)
CN1609
[2] Front
Assembly
(L-1)
Fig. D2
(S-4)
[6] Jack CBA
Fig. D3
E9400DC
Advertisement
Table of Contents
