Table of Contents
Advertisement
Available languages
Available languages
EN
ADJUSTING THE ARM REST
The standard adjustment of the arm rest suits
most people. Persons with very short forearms
(such as children) or very thick forearms may
need to adjust the arm rest.
There are three positions for the arm rest. To
adjust, undo the screw on the underside and
move the arm rest to the required position and
then replace the screw.
FIG. 5
BATTERIES
NOTE:
•
The machine runs on two 9 V alkaline
batteries (sold separately in Jula's
department store).
•
Only use charged batteries of the
recommended type.
•
Do not mix old and new batteries, or
different types of batteries.
Insertion
1.
Check that the power switch is in the
switched off position.
2.
Open the battery cover in the direction of
the arrow.
3.
Remove the old batteries and release the
cables.
4.
Connect the cables to the new batteries
with the correct polarity and insert the
batteries.
5.
Replace the battery cover.
FIG. 6
NOTE:
•
Remove the batteries if the machine is
not going to be used for a week or
longer, they can leak chemicals that
damage the electronic parts.
•
Switch the batteries round after 3–4
working hours to prolong battery life.
50
•
When the batteries are discharged "LOW
BATT" is shown in the right hand corner
of the display. Replace the batteries as
soon as possible.
WARNING!
Do not burn batteries – risk of explosion.
Recycle used batteries in accordance with
local regulations.
USE
CONTROL PANEL
Readings on the display
FIG. 7
1. Range reading DISC/NOTCH
Indicates the currently set range for DISC/
NOTCH.
2. Target reading
Shows the target category.
3. Status reading
Shows the machine status (sensitivity setting,
set range for DISC/NOTCH), battery charge
status and if SURF-ELIM has been selected,
or not.
4. Sensitivity reading (SENSITIVITY)
Shows the sensitivity of the machine.
5. Depth reading
Indicates the target depth.
DESCRIPTION OF CONTROL UNIT
FIG. 8
Advertisement
Table of Contents
