INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS BEFORE FIRST USE • Do not locate in areas of high foot traffic, • Read and follow all the instructions below even ensure the power cord and heater are in if you feel you are familiar with the heater. view to avoid accidents.
Installation • The use of extension cords may cause This heater is not designed for use within 1m or power voltage loss which will result in above a water source. damage to the heater this will NOT be Ensure that the heater is not positioned directly covered under warranty.
SPECIFIC SAFETY INSTRUCTIONS WARNINGS Do not use the heater in areas where there is a • DO NOT attempt to modify the heater, power risk of explosion or fire from flammable gases. cord, power plug or the supplied accessories Ensure that the heating area is kept clear of in any way.
ELECTRICAL DATA IMPORTANT Technical Specification This product is fitted with a sealed electrical Model GM135-019 connection plug that is compatible with the heater, the mains supply for New Zealand and meets Voltage: 220V-240V~ 50Hz the requirements of international standards. This...
ASSEMBLY INSTRUCTIONS INSTALLATION Step 1 -2 • As shown in figure A, turn over the Base and • Fix Screw Feet M6*30 onto the Screw Board, Base Cover, let Screw fix the Wheels through and adjust it into the same level as the Wheels. the small holes on the Base.
4. To turn off - switch heater to “O” at control panel and turn off power point. 5. Unplug lead from power point when not in use. Gasmate ® is a registered trademark of: Sitro Group Australia Pty Ltd www.gasmate.com.au Aber, Hamilton, N.Z.