External Optional Low Water Cut Off - UTICA BOILERS MAH-100 Manual

6.6 External Optional Low Water Cut Off

These guidelines are supplied when necessary to install an
additional Low Water Cut Off (LWCO), for sensing a low water
level condition in a boiler, as required by the Authority Having
Jurisdiction.
Follow LWCO manufacturer installation instructions for type of
LWCO selected in addition to these instructions.
LWCO shall be 120V/60HZ control and dry contacts sized for
load being connected. Wire control to boiler. See Figure 6-4.
Connect LWCO device to the system ground. Ground in
accordance with the requirements of the authority having
jurisdiction or, in the absence of such requirements, with the
National Electrical Code (NEC) or Canadian Electrical Code
CEC.
• Locate LWCO sensing device in the supply
piping, above the minimum height of boiler.
See Figure 6-3, Piping Diagram.
• Position control in HORIZONTAL piping to assure proper
boiler protection (upright or 90° rotation).
• For proper operation, sensing element of the LWCO
control shall be positioned in the tee to sense the main
water stream. Maintain minimum 1/4" spacing from pipe
walls. Element shall NOT contact the rear, or side walls of
the tee. See Figure 6-5.
• Install an air vent using a tee to avoid nuisance
shutdowns.
• Apply small amount of pipe sealant to threaded
connections. Use LWCO manufacturer suggested sealant.
• Arrange piping to prevent water dripping onto boiler.
• DO NOT install water shutoff valve between boiler and
LWCO sensing device.
FIGURE 6-4 - LWCO Wiring Diagram
120 V/60 HZ
L
1
N
G
Conduit or Power
Supply cord
(Polarized)
6 - HYDRONIC PIPING
Electrical Conduit
J-Box
BLK
WHT
GND
34
FIGURE 6-5 - Low Water Cutoff - Detail
NO
NO
YES
L
1
N
GND
120 V/60 HZ Socket
Low Water Cutoff (LWCO)
N.O
(Polarized) 120 V/60 HZ
Cord Set From Boiler
240013354 REV B [09/15/2021]