Panasonic NA-F70A7 Operating & Installation Instructions Manual page 19

Troubleshooting
Symptoms
Time indication increases or
does not change
Operation time is longer than
the time indication.
Operation does not stop even
after the reservation time.
No operation
No water supply
Water is supplied in the
middle of wash process.
The water level is too high for
the amount of laundry.
The water level is too low for
the amount of laundry.
Operation started with rinse,
but water is not supplied.
Operation suddenly changes
to rinse process in the middle
of spin.
Only spin is desired, but
operation starts with rinse.
Irregular rotation during spin
Power failure/
The breaker has tripped.
Water outage
Powder detergent remains
undissolved.
Points to be checked
● Time indication is approximate. Remaining time is corrected
during operation and displayed.
● The operation time may be longer if laundry is concentrated
on one side or the water supply or drainage is not good.
(P. 14 "U 11" "U 14")
● Power failure?
● Is the lid closed completely?
● Has the power fuse blown or the breaker tripped?
● Is the power plug inserted completely?
● Is the water faucet turned on?
● Did you press "Start"?
● Is the timer reservation set?
● Is the water faucet turned on?
● Water outage?
● Is the water supply filter clogged with dirt? (P. 11)
● If the water level drops, water is added automatically.
● With a large amount of laundry, water is added several times
automatically.
● If laundry is wet or there is water in the tub before operation,
the water level may be higher.
● With light clothes (of synthetic fibre, etc.), the water level may
be lower.
● If there is no water in the tub, water is supplied after spin.
● If there is water in the tub, water is supplied after water
discharge.
● If clothes are concentrated on one side of the tub, the washing
machine automatically corrects unevenness by starting rinse
process.
(Place clothes as evenly as possible.)
● The tub rotation speed is adjusted to reduce foaming during
spin.
● Operation will resume from the point where it was stopped
when the power is recovered (Auto Restart).
● When water supply is recovered, remove the water supply
hose, release turbid water from the faucet, and then start the
washing machine.
● Put the detergent in the detergent inlet. (P. 6)
15