Advertisement
8
Lift the inner edge guide towards you and slide it to the width of the
roll paper.
9
Load the roll paper spindle into the printer with the gray adapter on the
left.
Note:
Make sure the spindle fits between the rollers as shown.
10
Lift the end of the front edge guide and slide it to the width of the roll
paper.
11
Insert the leading edge of the paper into the paper feed slot until the
paper light turns on.
Note:
Make sure the leading edge is cut straight across to avoid paper
feeding problems.
12
Push the roll paper feeder back into the printer.
13
Carefully roll the paper into the printer to remove any slack.
Note:
If there is any slack in the paper, print quality may decline and paper
jams could occur.
14
Reattach the scrap paper box.
15
Check that the power light is on.
Install the driver
1
Download and run your product's software package:
www.epson.com/support/d870 (U.S.) or
www.epson.ca/support/d870 (Canada)
2
Follow the instructions on the screen to run the setup program.
3
When prompted, connect a USB 2.0 cable to the printer and your
computer.
Removing the paper
If you need to remove the roll paper from the product, make sure you follow
these steps.
1
Check that the printer's power light is on and not flashing.
2
Press the
switch button and wait for the
on.
3
Remove the scrap paper box.
.
paper light to turn
Advertisement
