Pioneer VSX-LX303 Instruction Manual page 85

Playing Back
Contents Connections
≫
Set the remote controller to the ZONE control mode (ZONE 2/ZONE 3)
( p83, 84), and then perform the following operations.
1. Point the remote controller at the unit, and press .
• "Z2" or "Z3" on the display of the main unit lights up.
• ZONE 3 cannot be turned ON unless "Speaker" - "Configuration" - "Zone
Speaker" in the System Setup menu (
2. Press the input selector of the input source you want to play in the separate
room. When operating on the main unit, press the ZONE CONTROL button
repeatedly to select "Z2" or "Z3", and select the input to playback in other
room with the input selector dial within 8 seconds.
3. To adjust the volume on the power amplifier in the separate room or the ZONE
speaker, adjust with VOL+/– on the remote controller. When operating on the
main unit, press the ZONE CONTROL button repeatedly to select "Z2" or "Z3",
and adjust with the MASTER VOLUME dial within 8 seconds.
• If you turn the unit to standby during multi-zone playback, the Z2 or Z3
indicator is dimmed, and the playback mode is switched to playback in a
separate room only. Setting ZONE 2/ZONE 3 to on while the unit is in standby
also switches the playback mode to playback in a separate room only.
• For ZONE 2 output, audio from externally connected AV components can
be output only when it is an analog or 2ch PCM audio signal. When the AV
component is connected to this unit with a digital coaxial cable or digital optical
cable, change the audio output of the AV component to the PCM output.
• For ZONE 3 output, audio from externally connected AV components can be
output only when it is an analog audio signal.
• DSD and Dolby TrueHD audio signals cannot be output to ZONE 2/ZONE 3
when selected with the "NET" or "USB" input selector.
• If ZONE 2/ZONE 3 is on, power consumption during standby will increase.
To set the function to off:
control mode. When operating on the main unit, press the ZONE 2 ON/OFF or
ZONE 3 ON/OFF button.
85
Front Panel≫ Rear Panel≫ Remote≫
Playback
≫
p105) is not set to "Zone 2/Zone 3".
Press while the remote controller is in the ZONE
Setup
≫ ≫