Skil RS582901 Owner's Manual page 12

To Attach/Detach Battery Pack
Lock the variable-speed trigger switch "OFF"
on the tool by depressing the lock-off button to
the locked position
To attach the battery pack:
Align the raised rib on the battery pack with the
grooves on the tool, and then slide the battery
pack onto the tool (Fig. 3).
To detach the battery pack:
Depress the battery-release button, located
on the front of the battery pack, to release the
battery pack. Pull the battery pack out and
remove it from the tool (Fig. 3).
NOTICE: When placing the battery pack on
the tool, be sure that the raised rib on the battery pack aligns with the groove in the tool and
that the latches snap into place properly. Improper attachment of the battery pack can cause
damage to internal components.
WARNING
when the tool is not in use or carrying at your side.
Variable-Speed Trigger Switch
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned "ON" or
"OFF" by depressing or releasing the
variable-speed trigger switch.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure (Fig. 4).
LED Light
Your tool is equipped with an LED, located
above the blade clamp on the tool. This LED
provides additional light on the surface of the
work piece for operation in lower-light areas.
The LED will automatically turn on with a slight
squeeze on the variable-speed trigger switch
before the tool starts running, and will turn off 8
to 12 seconds after the variable-speed trigger
switch is released.
The LED will rapidly flash when the tool and/or
battery pack becomes overloaded or too hot,
and the internal sensors will turn the tool off
12
.
Battery tools are always in operating condition. Therefore, the lock-
off button should always be depressed and in the locked position
Fig. 3
Detach
Battery-Release Button
Fig. 4
Variable-speed
Trigger Switch
Fig. 5
LED Light
Attach