Mitsubishi Heavy Industries FDT100VNP1VF2 Technical Manual page 226

13.2 Simple wired remote control (RCH-E3)
Notes:
Following functions of indoor unit series are not able to be set with this simple wired remote control (RCH-E3).
1. 4-fan speed setting (PHi/Hi/Me/Lo)
Names and functions of sections
Operation/Inspection lamp
During operation: Green
failure: Red
MODE button
Use to select the mode.
TEMP button
Use to raise the setting temperature.
TEMP button
Use to lower the setting temperature.
Operation mode display
: Cooling
: Dry
: Fan operation
: Heating
: Auto mode
Central control display
Displayed when controlling the
unit with the central control.
Control disable display
The lamp is lit for 3 seconds
when a disabled button is
pressed.
Installation of remote control
DO NOT install the remote control at the following places in order to avoid malfunction.
(1) Places exposed to direct sunlight
(2) Places near heat devices
(3) High humidity places
3-fan speed setting (Hi/Me/Lo)
Indoor unit No. display
(4) Hot surface or cold surface enough to generate condensation
(5) Places exposed to oil mist or steam directly
(6) Uneven surface
225
-
Remote control sensor
Button to start/stop the air
Button to set the fan speed
Indicates the No. of air
which is connected.
VRF series outdoor unit No. display
-
'16 • PAC-T-240
ON/OFF button
conditioner
-
FAN SPEED button
AIR CON No. button
conditioner
-
Fan speed display
Ventilation display
This is lit during the ventilation
operation.
Setting TEMP display
Error code display
PJZ000Z272
Rem
Wiring o
(In case of embe
12×7 Sl
In ca
0.3mm
L
Wirin
(1)
(2)
a