Mitsubishi Heavy Industries FDT100VNP1VF2 Technical Manual page 130

(2) Unit ON/OFF button
wireless
(a) Operation
(b) Details of operation
COOL, DRY
Function
Indoor temperature
Operation mode
COOL
DRY
HEAT
(3) Auto restart function
(a)
(b)
(i)
(ii)
(JA1)
(4) Installing two air-conditioners in the same room
When tow air-conditioners are installed in the room, use setting when the two air-conditioners are not operated with one wireless
remote control. Set the wireless remote control and indoor unit.
(a) Setting the wireless remote control
(i) Pull out the cover and take out batteries.
(ii) Disconnect the switching line next to the battery with wire cutters.
(iii) Insert batteries, Close the cover.
(b) Setting an indoor unit
(i) Turn off the power source, and turn it on after 1 minute.
(ii) Point the wireless remote control that was set according to the procedure
described on the left side at the indoor unit and send a signal by pressing
the ACL switch on the wireless remote control.
Since the signal is sent in about 6 seconds after the ACL switch is pressed,
point the wireless remote control at the indoor unit for some time.
(iii) Check that the reception buzzer sound "pip" is emitted from the indoor unit.
At completion of the setting, the indoor unit emits a buzzer sound "pip".
(If no reception tone is emitted, start the setting from the beginning again.)
HEAT
Fan speed Flap/Louver Timer switch
setting
wireless
Jumper wire (JA1)
129
- -
'16 • PAC-T-240 '09•SRK-DB-087D
Unit ON/OFF button
Disconnect
Reception
pip