Protecting The Environment; Troubleshooting Guide - DeWalt SDS MAX D25832 Instruction Manual

Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the
risk of eye injury, always wear approved eye protection
when performing this procedure.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
Accessories

WARNING: Since accessories, other than those
offered by D WALT, have not been tested with this
e
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only D
recommended accessories should be used with
this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center.
Repairs

WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should
be performed by a D WALT factory service center
e
or a D WALT authorized service center. Always use
e
identical replacement parts.
For assistance with your product, visit our website at www.dewalt.com for a list of service centers.
pRoBlEM
Tool will not start.
Reduced Power.
The chisel cannot be released.
WALT
e

TROUBLESHOOTING GUIDE

BE sURE To FolloW saFETY RUlEs aND INsTRUCTIoNs
possIBlE CaUsE
The extension cord and/or plug is defective.
Internal componets too hot.
Brushes worn out.
The extension cord is too long and/or its gauge
is inadequate.
The speed dial is set to a lower setting.
The voltage provided by the electric supply
is inadequate.
The chuck is not pulled back fully.

Protecting the Environment

Separate collection. Products and batteries
marked with this symbol must not be disposed
of with normal household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions.
spECIFICaTIoNs
D25832
aR
Made in:
Voltage 220 V
Frequency 50 Hz
Power
Impact Energy
Impact per Minute
Weight
solUTIoN
Have the extension cord and/or plug checked by a qualified
electrician and replaced if necessary.
Allow tool to cool down.
Have brushes replaced by an authorized D
Use an extension cord of an approved length and/or of
adequate gauge.
Rotate the speed dial to a higher setting suitable for the application.
Connect the hammer to an adequate electric supply.
Pull the chuck back as far as it will go and remove the chisel. Refer
to Inserting and Removing SDS MAX Chisels.
ENGlIsh
B3 B2 BR
China
120 V 220 V 127 V
60 Hz 50–60 Hz 60 Hz
1350 W
10.5 J (7.7 ft/lbs)
1450–2900 ipm
16.2 lbs (7.4 kg)
WALT service center.
e
23