DeWalt SDS MAX D25832 Instruction Manual page 24

ENGlIsh
Electronic Speed and Impact Control
(Fig. A)
The electronic speed and impact control allows the use of
smaller chisels without the risk of chisel breakage, chipping
into light and brittle materials without shattering and
optimal tool control for precise chiseling.
To set the speed dial 8 , turn the dial to the desired level.
The higher the number, the greater the speed and impact
energy. Dial settings make the tool extremely flexible and
adaptable for many different appli cations. The required
setting depends on the chisel size and hardness of material
being chipped.
Service Indicator LEDs (Fig. A)
Your chipping hammer has two service indicator LEDs
Refer to the table for more information on LED functionality.
lED Function Description
Red service
(flashing)
The red indicator LED
up if there is a fault with the tool
or the brushes have completely
worn out.
Yellow Brush service
(permanently on)
The yellow brushwear indicator
LED
brushes are nearly worn out,
indicating that the tool needs
servicing within the next 8 hours
of use.
Mode Selection (Fig. E)

WARNING: Do not select the operating mode when
the tool is running. Tool must come to a complete stop
before activating the mode selector button or damage
to the tool may result.
Your tool is equipped with a mode selector dial
select the mode appropriate to desired operation.
symbol Mode
Chisel
adjustment
Chipping
To Select a Mode
• Rotate the mode selector dial
arrow points to the symbol corresponding for the
desired mode.
22
.
9
9 lights
9 lights up when the carbon
to
4
application
Chisel position
adjustment
Light chipping, chiseling
and demolition
4 so that the
Fig. E
NoTE: The arrow on the mode selector dial
pointing at a mode symbol at all times. There are no
operable positions in between.
Performing an Application (Fig. F)

WARNING: TO REDUCE THE RISK OF PERSONAL
INJURY, ALWAYS ensure workpiece is anchored or
clamped firmly.
NoTE: Operating temperature of this tool is 19 ˚F to 104 ˚F
(-7 ˚C to +40 ˚C). Using the tool outside of this temperature
range will decrease the life of the tool.
1. Insert the appropriate chisel and rotate it by hand to
lock it into the desired position. Refer to Chisel and
Chisel Holder.
2. Using the mode selector dial
Refer to Mode Selection.
3. Adjust the bail/loop style auxiliary handle
as necessary.
Fig. F
4
2
4. Place the chisel on the desired location.
5. Depress the rocker switch
6. To stop the hammer, release the switch.
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Your D WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
tool care and regular cleaning.
4
4 must be
4 , select chipping mode .
2
1
1 .