EchoStar D-2400 IP User Manual page 27

2.2.1. SYSTEM SETUP MENU
This sub menu allows you to customize the system setup to match your installation. Note that
the menu page is dynamic which means that it changes with the selections you make. You
can customize:
Digital Satellite Receiver
Familiarization
I
System
To set the dish type you use.
I
LNBs
To set the amount of LNBs you have installed.
I
Polarity
To set the device that controls the signal polarity.
I
Switch
To set the switch type which you use to control the
dish installation (if used).
I
LNB1
To set the LNB type(s) you use.
I
Method (motorized only)
To set the scan method;
AutoSat (automatically calculate the satellite
positions from reference positions)
Manual (enter the satellites by manual search).
I
AutoSat (motorized, AutoSat only)
To confirm the selections you made and advance
to the AutoSat setup page (AutoSat only)
I
Set Limits (motorized, manual only)
To confirm the selections you made and advance
to the Set Limits page.
I
Satellite (fixed only)
To set the satellite you want to scan for the LNB.
I
Check Signal (fixed only)
To confirm the selections you made and advance
to the Check Signal page.
I
LNB Power (SMATV only)
To select the distribution type (cable=Off, IF=On).
I
Symbol Rate 1-4 (SMATV only)
To set the symbol rate you want to scan.
I
Search Channels (SMATV only)
To confirm the selections you made and advance
to the Search Channels page.
Section 4
4
Page 4 - 9