Connections; Operation - Panasonic YD-630AT Operating Instructions Manual

6、Connections
Electrode
Base metal
holder
Remote
controller
Fig.6.1a
 When using stick, please connect switch of welding method to "STICK", connect the
output cable to "+", connect Base Metal to "-", and make sure that connect base metal
to grounding firmly, just as Fig. 6.1a; When using gouging, please connect switch of
welding method to "GOUGING", connect the output cable to "+", connect Base Metal
to "-", and make sure that connect base metal to grounding firmly, just as Fig. 6.1b.
 The remote controller is optional with its order is TSM93067. When using remote
controller, please switch CONTROL in the operational panel to REMOTE, then
welding current adjustor in the operational panel won't work. Please adjust the welding
current knob in the remote controller for getting welding current or presetting current.
 The input power is AC415V, make sure that connect the power source shell to the
grounding firmly, just as Fig. 6.1c.
7、Operation
Turn on the switch of the switch box
Turn on the power switch in the operational panel
Turn off the power switch in the operational panel
Turn off the switch of the switch box
Gouging
Remote
Grounding
controller
Fig.6.1b
Start welding
End welding
Base metal
Grounding
* Power display lamp will light.
* The cooling fan will work.
* There will be output voltage
between the output ends.
(The no-load voltage is 75V with the
Prevent Electric Shock OFF),
whereas about 13V with it ON.)
* Please weld according to normal
operational procedure.
* Adjust the welding current by Weld
Cur. knob in the operational panel.
* Adjust the arc starting current by
ARC.START Cur. knob in the
operational panel.
* Adjust the arc force current by
ARC.FORCE Cur. knob in the
operational panel.
9
Input
Grounding
Fig.6.1c