● OPERATING INSTRUCTIONS ●
N
AME OF EACH PART
Indoor unit
<GN50/60>
Front panel
Air fi lter
(Nano plati-
num fi lter)
Air cleaning fi lter
(Anti-Allergy En-
zyme Filter, option)
Horizontal vane
Air outlet
<GN71/80>
Front panel
Air fi lter
(Nano platinum fi lter)
Air cleaning fi lter
(Electrostatic Anti-
Allergy Enzyme Filter,
option)
Air inlet
Air outlet
Horizontal vane
Display section
Operation indicator lamp
Emergency operation switch
Remote control receiving section
Outdoor unit
Outdoor units may be different in appearance.
En-3
Heat exchanger
Air inlet
Display section
Remote control
receiving section
Operation indicator lamp
Emergency
operation switch
Page 5
Heat exchanger
Page 5
Air inlet (back and side)
Refrigerant piping
Drainage hose
Air outlet
Drain outlet
Remote controller
Operation
display section
Temperature
buttons
Page 5
Operation
select button
Page 5
ECONO COOL
button
Page 8
POWERFUL
button
Page 7
i-save button
Page 7
Remote controller holder
• Install the remote
controller holder in a
place where the signal
can be received by the
indoor unit.
• When the remote
controller is not used,
place it in this holder.
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard from
the indoor unit when the
signal is received.
Battery replacement
indicator
Page 4
OFF/ON
(stop/operate) button
LONG button
Page 7
WIDE VANE control
button
Page 6
FAN speed control
button
Page 6
VANE control button
Page 6
TIME, TIMER set buttons
Page 4, 8
Increase time
Decrease time
WEEKLY TIMER
set buttons
Page 9
RESET button
Page 4
CLOCK button
Page 4
Lid
Slide the lid down to open
the remote controller. Slide
it down further to get to the
weekly timer buttons.
Only use the remote controller provided
with the unit.
Do not use other remote controllers.
If two or more indoor units are installed
in proximity to one another, an indoor
unit that is not intended to be operated
may respond to the remote controller.