Fault
Detergent residue in the ap-
pliance
Water marks on plastic
parts.
Wipeable or water-soluble
coatings are present inside
the appliance or on the door.
Stubborn white coatings are
present on tableware, inside
the appliance or the door.
Tea residue or lipstick marks
on tableware.
Cause
Tabs are used in the quick
or short programme. Dissolv-
ing time of the tab is not at-
tained.
Washing effect and dissolv-
ing performance are re-
duced after a prolonged
storage time or detergent is
very lumpy.
Due to laws of physics
droplet formation on plastic
surfaces is unavoidable.
After drying water marks are
visible.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
Too little detergent is being
used.
Washing programme selec-
ted too weak.
Washing temperature is too
low.
Too little detergent is being
used or is unsuitable.
Tableware has been pre-
cleaned too intensely. The
sensors chose a weaker pro-
gramme. Stubborn soiling
cannot be entirely removed.
Troubleshooting aus
Troubleshooting
Select a more intensive Programme
▶
or use Powder detergent.
Change your "detergent"
▶
→ Page 29.
Select a more intensive pro-
▶
gramme.
Position tableware at an angle.
▶
→ "Arrange tableware", Page 32
Use rinse aid.
▶
→ "Rinse aid", Page 27
Change your "detergent"
▶
→ Page 29.
Clean the appliance mechanically.
▶
Change your "detergent"
▶
→ Page 29.
Clean the appliance mechanically.
▶
Increase the amount of detergent
▶
used or change "Detergent "
→ Page 29.
Select a more intensive washing
▶
programme.
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 11
Select a programme with a higher
▶
washing temperature.
Use a suitable "Detergent "
▶
→ Page 29 and follow the manufac-
turer's instructions for the amount
to be used.
Only remove large remnants of food
▶
and do not prerinse tableware.
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 11
49