Page 1
MP6810 (M6) (M8) 90° BRACKET (M10) (M6) Manufactured on behalf of WEAR GLOVES DURING ASSEMBLY LIMITED Maypole Ltd, Birmingham UK www.maypole.ltd.uk sales@maypoleltd.co.uk NOTE: TIGHTEN FIXINGS TO TORQUES PRESCRIBED IN THE LIST OF TOOLS...
Page 2
DO NOT FULLY TIGHTEN FIXINGS AT THIS STAGE REMOVE PRE-FITTED BOLT UNSCREW AS FAR AS POSSIBLE WITHOUT REMOVING TO DRAW BAR CLIP CABLES TO THE BEAM INSERT BOLT TO DRAW BAR FULLY TIGHTEN ALL FIXINGS IN SECTIONS A-C...
Page 3
CAREFULLY TURN THE TRAILER OVER SO WHEELS ARE ON THE GROUND INSERT THE PIN FULLY TIGHTEN THE WHEEL NUTS CHECK THAT THE BASE PANEL IS SECURELY CLAMPED DOWN ON TO THE DRAW BAR FULLY TIGHTEN FIXINGS IMMEDIATELY...
Page 4
DO NOT FULLY TIGHTEN FIXINGS IN SECTIONS G-J UNTIL INSTRUCTED TO DO SO Qty:...
Page 5
FIT THE 90º BRACKETS INSIDE THE MUDGUARD 90º BRACKETS...
Page 6
CLOSE AND SECURE TAILGATE THEN FULLY TIGHTEN ALL FIXINGS IN SECTIONS G-K Road trailers must be inspected prior to use to ensure they are of a road worthy • Wheels After assembly and again condition; it is a legal requirement that all trailers are maintained and comply •...
Need help?
Do you have a question about the MP6810 and is the answer not in the manual?
Questions and answers