Related Manuals for SEC CELLYTE 2ETG OPzV Gel
Summary of Contents for SEC CELLYTE 2ETG OPzV Gel
- Page 1 CELLYTE 2ETG OPzV Gel STATIONARY BATTERIES INSTALLATION and OPERATING INSTRUCTIONS Supplied Worldwide by : SEC Industrial Battery Last Revised May 2011...
-
Page 2: Table Of Contents
TABLE OF CONTENTS SECTION CONTENT PAGE SECTION CONTENT PAGE GENERAL INFORMATION Electrical Connections Battery Characteristics 5.4.1 Cabling recommendations 5.4.2 Terminal Preparation 5.4.3 Connector Installation SAFETY INFORMATION 5.4.4 Voltage Checks General Information 5.4.5 Battery to Charger Connection Sulphuric Acid 5.4.6 Paralleling of Batteries Gassing Electrical Shock OPERATION... -
Page 3: General Information
Electrical shock or burns, acid burns and fire can Contact SEC if there are any questions regarding result if proper safety precautions are not followed. gassing or ventilation. -
Page 4: Short Term Storage
Do not stack / top load pallets, or allow any other battery location designed, engineered material to be stored on top of the pallets or possible monitored to minimize temperature variations. battery damage may occur. Do not store where the possibility of metallic objects falling on the battery 5.1.3 Ventilation may occur. -
Page 5: Installation
Installation 5.3.1 General CAUTION: Remove all rings and watches before CELLYTE 2ETG Gel OPzV cells up to 1500 ah (ETG installing the intercell inter connectors on the 1700) can be installed in the vertical and horizontal cells. Ensure that all tools are insulated with vinyl position. -
Page 6: Voltage Checks
The float voltage is sometimes known as the charge voltages differ between the batteries. continuous charge voltage. It is very important that it Ask SEC for advice on paralleling flooded and VR be calculated and set properly for maximum battery batteries. -
Page 7: Float Voltage Requirements
100 amps. If a very rapid recharge is desired, and will be available when needed. Proper record please contact SEC for more instructions. keeping will ensure that, if there is a problem with a battery, the customer can demonstrate the batteries Recharge were correctly used and so maintain the warranty. -
Page 8: Maintenance Records
(if available).This can be accurately The ratings test discharge is usually performed measured using the SEC recommended shunt. Which using a suitably designed and sized load bank to can be supplied as an optional extra with the battery. -
Page 9: Discharge Test Notes
DISCHARGE TEST NOTES: When batteries are new, the battery may deliver only 95% of rated capacity. Full capacity will be obtained after 3-6 months in float service or after 10 cycles. String voltage should be measured at the battery terminals, not at the load connections. Accurate meters are essential for correct test results. -
Page 10: Battery Maintenance Register
SEC BATTERY MAINTENANCE REGISTER Maintenance Description Date Industrial Battery Co. Industrial Battery Co. -
Page 11: Technical Support
11 TECHNICAL SUPPORT SEC is always ready to assist you in your installation and operation of SEC CELLYTE 2ETG OPzV range batteries. If you have any questions on any portion of this manual, please do not hesitate to call or fax any of... -
Page 13: Battery Report
SEC BATTERY REPORT Installed by: Representative: Operating Company: Date: Time: Address/Location: Battery Information Type of Battery: No. of Cells/String: String Float Voltage: Installation Date: No. of Strings/Battery: Float Voltage/ Cell: Battery Charge Current: Battery Code: Float Current: Charging Equipment: Ambient Temperature:...
Need help?
Do you have a question about the CELLYTE 2ETG OPzV Gel and is the answer not in the manual?
Questions and answers