Table of Contents
Advertisement
Chapter 3: Testing and Troubleshooting
A "ping" test will verify that the module is operating properly.
NOTE
However, both server and client workstations must have their
own unique IP Addresses.
If failures occur, refer to Section 3.3, Using LANVIEW, in this chapter.
MMAC-M3FNB with IRM3
3.3 USING LANVIEW
The FOMIM uses Cabletron Systems built-in visual diagnostic and status
monitoring system called LANVIEW. With LANVIEW, network
troubleshooting personnel can quickly scan LEDs to observe network
status, or diagnose network problems. Figure 1-2 in Chapter 1 shows the
location of the LANVIEW LEDs.
3-4
Client Workstation
Figure 3-1 Pre-Installation Test
File Server Workstation
0494109
FOMIM User's Guide
Advertisement
Table of Contents
