Cisco Meraki MT20 Installation Manual page 4

Open/close detection
Table of Contents


Screws Mount
As shown in the picture below, once the battery cover is removed, the two screws can be inserted through the holes. After the screws are tightly fitted, the
battery compartment needs to be closed to ensure security of the sensor. Ideally, the main sensor body should be mounted on the door. Make sure that the grey
panel with the magnet icon faces toward the outer edge of the door where you intend to install the magnet cover.
The magnet cover can also be removed to access the holes for the screw. Ideally, this part should be mounted on the door frame. Make sure the grey side with
the magnet symbol faces toward the sensor.
NOTE: The grey panel on the sensor and the magnet cover should be facing toward each other. This orientation will always have the magnet poles in
opposite directions.


Table of Contents

This manual is also suitable for:

Meraki mt20 seriesMeraki mt20-h

Table of Contents