Connection And Installation; Ssd Installation - EverFocus eNVP-JNN-IV-D0008 User Manual

2. Connection and Installation

2.1 SSD Installation

Users can install up to two 2.5" SSD into the AI NVR for recording. Please follow the steps below
to install the SSD.
Note: The AI NVR does not support hot swap for the SSD. Ensure to power off the device
before removing the SSD. Also ensure to remove the SSD only after the power was
completely shut off. This would protect and extend the operating life of the SSD.
1. Make sure the AI NVR is powered-off. Unlock the SSD Tray (turn clockwise) using the
supplied SSD Lock Key.
2. To install the SSD, pull the Release Latch to open the SSD Tray Arm.
eNVP-JNN-IV-D0008 / eNVP-JTX-IV-D0008 / eNVP-JNX-IV-D0008
Release Latch SSD Tray Arm
Lock
7
Chapter
2
Unlock