Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Audio Unlimited SPK-SHOWER
Summary of Contents for Audio Unlimited SPK-SHOWER
- Page 1 SPK-SHOWER showerPOD 900MHz Wireless Shower Speaker USER MANUAL USER MANUAL USER MANUAL USER MANUAL www.audio www.audio- - - - unlimited.com www.audio www.audio www.cablesunlimited.com www.cablesunlimited.com www.cablesunlimited.com www.cablesunlimited.com unlimited.com unlimited.com unlimited.com...
- Page 2 Introduction & General Instructions Overview This Audio Unlimited™ showerPOD 900MHz wireless shower speaker system utilizes the latest advances in wireless transmission technology to deliver dynamic, high-quality audio from virtually any audio/video device, indoors up to 150 feet away. Simply connect the transmitter to a desired audio source: i-Pod, MP3, CD, DVD, Hi-Fi system or radio to enjoy wireless, full spectrum sound without complicated wiring and installation while having a shower.
- Page 3 Parts Identification Transmitter Receiver Adapter...
- Page 4 Transmitter Operation 1. Plug the included AC adapter into a standard wall outlet 2. Turn on the power switch on rear transmitter. A blue indicator flashes when the AC adapter is plugged in. If the blue POWER indicator does not illuminate, ensure the adapter is plugged in. 3.
- Page 5 AC Operation 1. To operate the speaker using AC power, plug the 9V power adapter into a standard wall outlet 2. To insert the power adapter connector plugs firmly into the DC IN jacks located underneath the speaker Speaker Operation 1.
- Page 6 Speaker Operation Note: When transmitting over long distances, the audio signal becomes weaker and interference increases. If the source signal is too weak for reception, the transmitter automatically switches off, blue indicator will flash after approximately four minutes to protect the unit and save power. If the source signal returns to an adequate level, the transmitter automatically switches back on.
- Page 7 Ensure the connected audio device is switched on and producing a signal. Ensure that the volume level is set to a moderate level Distortion Ensure the speaker and transmitter are operating on the same frequency. If not, press the AUTO TUNE button until both units are operating on the same frequency Switch the CHANNEL selector position (1 or 2) on the transmitter base and press the AUTO TUNE button the speaker until the matching frequency is...
- Page 8 through the headphone jack does not have the signal strength required by the transmitter. Raising the volume of your device will increase the signal strength to the transmitter. The blue signal LED will light when the required signal strength from your device is reached. We recommend that you keep the volume set on your iPod or MP3 player at a minimum of ¾...
Need help?
Do you have a question about the SPK-SHOWER and is the answer not in the manual?
Questions and answers