Advertisement
Available languages
Available languages
Using the Tool
Lining up Tiles on a Floor
Position the tool on the smooth, flat floor where
1.
you are ready to begin placing tiles.
Press the Power button
2.
display the horizontal and vertical laser lines.
Line up your tiles along the laser lines (Figure
3.
Once you have placed all the tiles that will fit along
4.
the current laser lines, reposition the tool for the
next tiles to be placed on the floor.
When you are finished using the tool, press the
5.
Power button
to turn off the laser lines.
Lining up Objects on a Wall
Position the tool on the smooth, flat wall where
1.
you are ready to place tiles, pictures, or other
objects.
Press the Power button
2.
display the horizontal and vertical laser lines.
Use the Level Vials to make sure the horizontal
3.
laser line is level on the wall.
• Use Level Vial
A 4
horizontally on the wall.
• Use Level Vial
A 6
horizontally on the wall.
• Use Level Vial
A 5
laser lines at a 45° angle on the wall.
(Figure
) to
A 1
C
(Figure
) to
A 1
to level laser line
A 3
to level laser line
A 2
to correctly position the
Use the 2 connected push pins and/or the third
4.
push pin on the bottom of the tool to attach the
tool to the wall. The pins can be pushed straight in
or at an angle into the wall (Figure
• To use the 2 connected push pins on the top of
the tool, lift them up and then push them into the
wall (Figure
D 2
• To use the third push pin on the bottom of the
).
tool, pull it up and out of the tool. Then push
it through any of the 3 outer holes (Figure
-
).
9
11
Line up your objects on the wall.
5.
If you need to place more objects on the wall,
6.
remove the pins and reposition the tool on the wall
as you did before.
When you are finished using the tool, press the
7.
Power button
Maintenance
• When the tool is not in use, clean the exterior parts
with a damp cloth, wipe the tool with a soft dry cloth
to make sure it is dry, and then store the tool in the
pouch provided.
• Although the tool exterior is solvent resistant,
NEVER use solvents to clean the tool.
• Do not store the tool at temperatures below -16 ˚F
(-25 ˚C) or above 158 ˚F (70 ˚C).
• To maintain the accuracy of your work, check the
tool often to make sure it is properly calibrated.
• Calibration checks and other maintenance repairs
may be performed by D
).
E
and
).
D 3
to turn off the laser lines.
WALT service centers.
E
E
A
9
Advertisement
