DeWalt DW080LRS Manual page 21

Controlling the Laser from up to 50' Away
The DW080LRS/LGS remote control allows you to operate and
set up the laser from up to 50' away. The LED light on the remote
control (Figure ) indicates a signal is being transmitted from the
B 1
DW080LRS/LGS laser unit.
You can use all the buttons on the remote's keypad to control the
laser unit. To completely power OFF a DW080LRS/LGS laser unit
using the Remote keypad, simultaneously press the X-Y axis button
) and the Slope Mode button
(Figure
B 5
By default, the laser unit is not paired to a remote (the laser unit is
in Public mode). LEDs on the laser unit and the remote will indicate
that they are not paired.
UNLOCKED
in Public Mode
Description A laser is in Public Mode
if it is not paired with a
remote.
A remote is in Public
Mode if it is not paired
with a laser.
Control A Public laser can be
controlled by more
than one Public remote
(Figure
K 1
A Public remote can
control more than one
Public laser (Figure
).
K 2
LEDs
The unlocked
will be lit on the laser
keypad (Figure
).
K 2
The locked LED on the
remote will NOT be lit
(Figure
K 1
(Figure
B 2
LOCKED
in Private Mode
A laser is in Private
Mode if it is paired
with a remote.
A remote is in Private
Mode if it is paired
with a laser.
A Private laser can only
be controlled by the
remote to which it is
). paired (Figure
A Private remote can
only control the laser
to which it is paired
(Figure ).
L
The locked LED
LED
on the laser will be lit
(Figure ).
and
K 1 L
The locked LED on
the remote WILL be lit
and ). (Figure ).
K 2
L
Pairing the Laser to a Remote
To pair the laser unit to one remote, simultaneously press and hold
on the laser keypad and
15˚/45˚/90˚
and the remote will indicate that they are paired (in Private mode).
• The laser unit will beep twice and the locked
) on the laser keypad will blink twice and then remain green
A 4
to indicate that currently only one remote can control the laser
(Figure )
L
• The locked LED on the remote (Figure
).
then remain red.
If You Stop Using a Paired Remote
If you stop using a remote that has been paired with a laser unit (remote
is in Private mode), the remote will automatically reset back to Public
mode. You will not be able to use the remote to control the laser unit. The
Lock LED on the laser keypad will remain lit, but you can only use the
laser keypad to control the laser.
If...
No buttons are pressed on the
remote keypad right after it is
paired with a laser unit.
Buttons are pressed on the
remote keypad after it is paired
with a laser unit.
).
L
To change the remote back to Private mode so it can again control the
laser unit, press and hold
If You Turn OFF a Paired Laser Unit
If you use the laser keypad to turn off a laser unit that is paired with a
remote, turning the laser back on will not automatically re-establish the
Private connection with the same remote again.
• The remote that had been paired with the laser unit will remain in
Private mode with the Lock LED still lit, but it will not be able to control
any laser unit.
• The laser unit will default to Public mode and can be controlled by any
remote except the remote that is still in private mode.
on the remote. LEDs on the laser
15˚/45˚/90˚
LED (Figure
) will blink twice and
B 8
Result
Within 1 minute, the remote will
be reset back to Public mode.
After 8 hours, the remote will be
reset back to Public mode.
on the remote keypad.
15˚/45˚/90˚
E
21