Cleaning & Maintenance; Cleaning The Filters; Cleaning The Spray Arms - AEG Inventum VVW6025A Instruction Manual

6
cleaning & maintenance
Cleaning the dishwasher regularly, prolongs the dishwasher's service life.
Check before cleaning the dishwasher if it's is turned off. Unplug the dishwasher and turn off the tap.
Clean the outside of the dishwasher with a damp cloth. To prevent odors from forming within the dishwasher, clean the seals
of the door regularly with a soft damp cloth.
To prevent the dishwasher from getting clogged, we advise to clean the dishwasher regularly with a special cleanser. Fill the
detergent reservoir with detergant, select a cycle with a high temperature and start the program. If this is insufficient, use a
special cleanser for dishwasher and follow the instructions on the packaging.
Clean the filters and the spray arms once a week.

CLEANING THE FILTERS

Check once a week if there is any residue on the filters. Remove the filters and clean them thoroughly under the water tap.
The filter system consist of three components: the micro filter (2a), the main filter (2b) and the sieve (3c).
1. To remove the filters, turn the main filter (2b) anti-clockwise and pull it upwards. The micro filter (2a) is attached to the
main filter.
2. Pull the main filter from the micro filter and clean both parts with warm water using a dishwashing brush.
3. Take the sieve out of the dishwasher and clean it with warm water and if needed a dishwashing brush. Place the sieve
back in the dishwasher.
4. Place the main filter in the micro filter with the markings allined. Re-fit the filters in the sieve and turn it clockwise to fixe
it.
• Do not use the dishwasher when there are no filters in place.
• Incorrect fitting of one the filters will result in the dishwasher no longer delivering maximum performance.
• Make sure the filters are clean. This ensures proper functioning of the dishwasher.

CLEANING THE SPRAY ARMS

Check the nozzles of the upper and lower spray arms regularly for waste. Waste can block the nozzles and bearing in the
spray arms. Remove the clogging in the spray arms and clean them with warm water.
• Unscrew the nut of the upper spray arm to remove it. Remove the spray arm.
• Remove the lower spray arm by pulling it upwards.
• Clean the spray arm with warm water.
• Make sure that the nut is perfectly tightened when refitting the upper spray
arm.
43
English •