Table of Contents
Advertisement
Operating the appliance
en
E flashes: The childproof lock is
■
active and the programme selector
was adjusted. To prevent the
programme from stopping, turn the
programme selector back to the
original programme. The symbol
lights up again.
The childproof lock can remain
Note:
activated until you wish to start the next
programme, even after switching off the
machine.
You must then deactivate the childproof
lock before starting the programme and
activate it again as necessary once the
programme has started.
Adding laundry
After starting the programme, you can
add or remove laundry as required.
To do this, press the Start/
The Start/Pause indicator lamp flashes
and the machine checks whether it is
possible to add laundry.
Do not leave the washing
Note:
machine door open for too long when
adding laundry as water from the
laundry may leak out.
If the display panel shows:
the
Both
YES
■
it is possible to add laundry.
A flashing
NO
■
and ¼ light up.
Do not open the door until
and the ¼ symbols are lit.
YES
A flashing
NO
■
possible to add laundry.
For safety reasons, the washing
machine door remains locked when
the water level or temperature is
high, or while the drum is rotating,
and it is not possible to add laundry.
To continue the programme, press
the
/Pause button. The
Start
programme continues automatically.
20
button.
Pause
and ¼ symbols lit up,
symbol, wait until
both
symbol, it is not
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
Press Start/
1.
Select the other programme.
2.
Press
3.
programme starts from the
beginning.
Cancel the programme
Programmes at high temperatures:
Press Start/
1.
To cool the laundry: Select
2.
Press
3.
For programmes at low temperatures:
Press Start/
1.
Select
2.
Press
3.
Programme end during rinse
hold
– – – B appears on the display panel
and the Start/Pause button indicator
lamp flashes.
To end the programme, set the
programme selector to Spin/Drain or
select a spin speed. Then press the
/Pause button.
Start
YES
Programme end
the
appears on the display panel and
End
the Start/Pause button indicator lamp is
off.
If the Q symbol appears on the display
panel, the washing machine has
detected too much foam during the
wash programme and automatically
switched on a rinse cycle to remove the
foam.
Add less detergent for the next
Note:
washing cycle with the same load.
.
Pause
/Pause. The new
Start
.
Pause
/Pause.
Start
.
Pause
or
.
Spin
Drain
/Pause.
Start
.
Rinse
Advertisement
Table of Contents
