Table of Contents
Advertisement
Cleaning and maintenance
en
Switch off the appliance. Disconnect
2.
the mains plug.
Open and remove the service flap.
3.
Take the drain hose out of the
4.
retainer.
Remove the sealing cap, allow the
detergent solution to flow out into a
suitable container.
Replace the sealing cap and place
the drainage hose in the retainer.
Carefully unscrew the pump cover,
5.
residual water may leak out.
Clean the interior, pump cover
thread and pump housing. The
impeller in the detergent solution
pump must be able to rotate.
Refit the pump cover and screw it on
tightly. The handle must be in a
vertical position.
Place the service flap back on, lock
6.
it into place, and close it.
24
To prevent unused detergent from
Note:
flowing straight into the drain during the
next wash: Pour 1 litre of water into
compartment
and start the
II
programme.
The drain hose at the siphon
is blocked
Switch off the appliance. Disconnect
1.
the mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose, residual
water may leak out.
Clean the drainage hose and siphon
3.
connecting piece.
Reattach the drainage hose and
4.
secure the connection using the
hose clamp.
Filter in the water supply
blocked
For this, first reduce the water pressure
in the supply hose:
Turn off the water tap.
1.
Select any programme (except
2.
Rinse//Spin/Drain).
Press
. Allow the programme to
3.
Start
run for approximately 40 seconds.
Set the programme selector to
4.
Disconnect the mains plug.
Clean the filter on the water tap:
5.
Drain
.
Off
Advertisement
Table of Contents
