Table of Contents
Advertisement
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. In
order to remove any water which may
be left over from the test, run the first
washing cycle
without
Notes
The washing machine
■
correctly installed
From ~ Page 31
Never use a damaged machine.
■
Inform your after-sales service.
Check the machine.
1.
Remove the protective film from the
2.
control panel.
Connect the mains plug.
3.
Turn on the water tap.
4.
Close the washing machine door (do
5.
not load any laundry).
Select the
6.
Cottons
set the temperature to
Open the detergent drawer.
7.
Pour approx. 1 litre of water into
8.
compartment
Pour standard detergent into
9.
compartment
To prevent foaming, only use
Note:
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
for wool or delicates.
Close the detergent drawer.
10.
Press
.
11.
Start
Switch off the appliance at the end of
12.
the programme.
Your washing machine is now ready to
use.
any laundry.
must be
and
connected
programme and
.
60 °C
.
II
.
II
Positioning and connecting
Transportation
e.g. when moving home
Preparatory work:
Turn off the water tap.
1.
Reduce the water pressure in the
2.
supply hose.
Maintenance – filter in the water
supply ~ Page 24
Drain the remaining detergent
3.
solution.
.
Maintenance – detergent solution
pump blocked ~ Page 23
Disconnect the washing machine
4.
from the mains.
Remove the hoses.
5.
en
37
Advertisement
Table of Contents
