Advertisement
№ Description
A
Insert the mounting shaft here.
B
Insert the hexagon screws here.
Bending
1. Make sure that the mounting plate for dies (4) is attached to the body. See Figure 1 to know
the positions of the holes required for bending.
2. Make sure that the stop (2) is closed.
3. Move the vice unit (5–9, 15) to the first position on the mounting plate arm.
4. Insert the spring pin (19) of the die (13) in the little hole without thread of the mounting plate.
5. Attach the die by screwing the hexagon screw (18) into the little threaded hole of the mounting
plate.
6. Move the folding block unit (16, 17, 22–24) all the way back. You might have to loosen the
folding block locking plate (21) by loosening the two hexagon screws (20). Do not secure the
locking plate at this moment.
7. Set the shaft against the die and close de vice so that it clamps the workpiece against the die.
8. Move the folding block until it touches the workpiece and until its front plat (16) is flush with the
vice surface (8). Secure the folding block by tightening the two screws.
9. Move the folding block to the left using the handle (27) until reaching the desired folding angle.
Consider the "spring-back" effect.
10. To repeat 90° angle foldings, use the angle metre unit (10–12). Screw the shaft (11) in the die.
Slide the stop (10) on the shaft to the desired position (depending on the length of your work-
piece). Thus the folding is "stopped" at the right position.
11. Should you wish to repeat foldings at the same angle (apart from 90° angles), use the stop (2).
Fold coils
1. Remove the mounting plate for dies (4) by removing the two hexagon screws. Loosen the
stop (2).
2. Pull the folding block unit (16, 17, 22–24) all the way back. Remove the front plate of the fold-
ing block (16) by unscrewing the corresponding hexagon screw (17). Thus the swivel joint (22)
of the folding blocks is exposed.
For steps 3, 4 and 8 see Figure 2
3. Attach the spring-forming mounting die (32) with two hexagon screws (in position 1).
4. Set the spring pin (25) of the spring-forming die "A" (31) in hole 3 and attach the long hexagon
screw (26) in position 2.
For steps 5, 7 and 8 see Figure 3
5. Set the material to be folded into the hole of die "A" (31).
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Figure 1: Position of holes for fixing the dies
Item 61856
№ Description
C
Insert the die springs here.
D
Insert the hexagon die screw here.
Page 5
04
2021-1
Advertisement
