Advertisement
Quick Links
Operation Manual
360° Sheet Metal Folder
61856
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignific -
antly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Related Manuals for WilTec 61856
Summary of Contents for WilTec 61856
- Page 1 Operation Manual 360° Sheet Metal Folder 61856 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignific - antly.
- Page 2 All rights reserved. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 (㎜) 30×8 for round steel up to (㎜) for square steel up to (㎜) 13 Folding angle (°) 0–360 Weight (kg) © by WilTec Wildanger Technik GmbH Item 61856 Page 3 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 4 12. In order to form springs, loosen the stop (2) and slightly lift the shaft to be formed while folding the shaft around the die. When beginning and finishing the spring, form an entire 360° ring as described in step 11. © by WilTec Wildanger Technik GmbH Item 61856 Page 4 http://www.WilTec.de...
- Page 5 4. Set the spring pin (25) of the spring-forming die “A” (31) in hole 3 and attach the long hexagon screw (26) in position 2. For steps 5, 7 and 8 see Figure 3 5. Set the material to be folded into the hole of die “A” (31). © by WilTec Wildanger Technik GmbH Item 61856 Page 5 http://www.WilTec.de http://www.aoyue.eu...
- Page 6 8. Now set the spring pin (25) of the spring-forming die “B” (30) into the holes 4 and 5. 9. Finish folding by completely lagging the dies. Figure 3 Figure 2 © by WilTec Wildanger Technik GmbH Item 61856 Page 6 http://www.WilTec.de http://www.aoyue.eu...
- Page 7 Exploded view and parts list © by WilTec Wildanger Technik GmbH Item 61856 Page 7 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 8 Spring-forming die Important notice: The reprint or reproduction, even of excerpts, and any commercial use, even in part of this instructions manual require the written permission of WilTec Wildanger Technik GmbH. © by WilTec Wildanger Technik GmbH Item 61856 Page 8 http://www.WilTec.de...