Installing The New Thermostat Head - Silvercrest 354199 2010 Short Manual

Installing the New Thermostat Head

To fit the device to Danfoss radiator valves, you
need the adapter (15) provided. To determine
which adapter (15) fits which radiator valve, please
refer to Fig. B - D on the fold-out page.
Caution! Risk of trapping be-
tween the halves of the adapter!
▸ During assembly, be careful not to
jam your fingers between the halves
of the adapter!
Caution! Risk of cuts! The
adapters and stem extension
supplied could have sharp edges.
▸ Smoothen any burrs at the breakout
points of the adapter used with the
aid of an appropriate tool.
The notches (14) ensure the adapter (15) fits per-
fectly.
1. If required, slide the adapter (15) that fits the
radiator valve onto the radiator valve until the
adapter (15) snaps into place.
If necessary, use a screwdriver to slightly prise
open the adapter (15) in the area of the screw.
2. Fix the corresponding adapter (15) with the
screw and nut supplied (see Fig. B and Fig. C
on the fold-out page).
In the case of the RAV valve, the stem extension (16)
27
Gi