Installing The Canopy - Hunter Original Installation Manual

1886
IMPORTANT
Your canopy comes pre-assembled. Uninstall the canopy screws using a #1 Phillips-head screwdriver and separate the two halves of the
canopy before continuing to step 1.
1
Canopy
Assembly Screw
Assemble canopy halves around pipe, and loosely
install the canopy assembly screws. Slide canopy up
close to ceiling.
IMPORTANT
DO NOT TURN FAN ON UNTIL LUBRICATION HAS BEEN ADDED. TO OPERATE THE FAN WITHOUT OIL OR WITH LOW OIL WILL VOID
YOUR WARRANTY.
Note:
Your fan has been shipped without oil in the motor. A tube of high grade SAE 10 non-detergent oil is packaged in the hardware bag.
1
Remove cap if present. Cut the tip off the end of the tube.
Your Original Hunter's Unique Lubricating System
The bearings in your Hunter Original Ceiling Fan are submerged in oil, which lubricates all bearing surfaces as the fan operates. We recommend periodically checking the oil to
ensure the correct level is maintained. This unique lubrication system is one reason why your Hunter Original Ceiling Fan will last a lifetime.
7
Ceiling Bracket

Installing the Canopy

Oil Bottle
Downrod Hanging Fan
3
Canopy
Assembly Screw
Tighten the canopy assembly screws using
a #2 Phillips-head screwdriver.
Lubrication
2
Place the tube into the oil hole and gently squeeze the tube to empty the oil
into the fan's reservoir.
NOTE: To avoid overflowing during filling, add a third of the oil from the tube
at a time. Pause for 30 seconds between each third to allow the oil to settle
in the fan. Be sure to add all of the oil in the tube to the fan.
Wiring Canopy
4
Canopy
Set Screw
Tighten the canopy set screw using a #1
Phillips-head screwdriver.
Oil Bottle
Oil Hole
Blades Operation Troubleshooting