Hanging The Fan - Hunter Original Installation Manual

Remove any existing bracket prior to installation. Only use the provided Hunter
ceiling bracket that came in your fan's box.
Cross Brace
OFF
Do this first!
Drill two (2) 11/64" diameter
holes 2-9/16" apart through the
back of the outlet box into the
cross brace 2" deep. These holes
are for the U-bracket bolts. Install
rubber bushing and pin into the
U-bracket. Use a 11 mm wrench
to install the (2) 3 1/2" lag bolts,
found in the hardware bag, to
secure the U-bracket to the joist
WARNING
To avoid possible electrical shock, before
installing your fan, disconnect the power by
turning off the circuit breakers to the outlet
box associated with the wall switch location.
IMPORTANT
TO SECURELY HANG THE FAN, CAREFULLY FOLLOW THE STEPS ON PAGES 7 AND 8. BE SURE TO TIGHTEN THE HANGER PIPE INTO
THE FAN AND THE HANGER BRACKET ONTO THE PIPE. TIGHTEN THE 2 SET SCREWS, AS DESCRIBED IN STEP 7, TO PREVENT THE
FAN FROM FALLING. YOUR FAN MAY WEIGH UP TO 50 LBS. ALL OF THE FOLLOWING STEPS MUST BE FOLLOWED IN ORDER TO
ENSURE A SECURE MOUNTING.
Wires
1
Hanger Pipe
Motor Housing
Feed the wires from the top of the
fan motor through the hanger pipe
Ceiling Bracket Downrod
Installing the Ceiling Hardware
Outlet Box
Ceiling
Rubber Bushing
and Pin
Exploded View

Hanging the Fan

Motor Housing
Set Screw
2
Loosen the motor housing set
screw (do not completely remove
from the fan) in the neck of the fan
motor housing.
Hanging Fan Wiring
U-Bracket
Installed View
Lag Bolt
3
Screw the pipe into the fan until
tight (at least 4-1/2 turns)
Canopy Blades
IMPORTANT
DO NOT USE LUBRICANT ON SCREWS
bag
3-1/2" Lag Bolt
4
Excess wiring can be cut, but leave at
least 8" extending from the top of the
hanger pipe. NOTE: Some of the pipe
threads may still be visible
Operation Troubleshooting
1886
x2
4