Table of Contents
Advertisement
10. After removing the stopper (A) using stopper pliers (B).
11. Disconnect the stop ring (A), overrunning clutch (B), internal gear (C) and planet shaft (D).
12. Reassembly is the reverse of disassembly.
Using a suitable pulling tool (A), pull the overrunning clutch stop ring (B) over the stopper (C).
INSPECTION
ARMATURE INSPECTION AND TEST
1. Remove the starter.
2. Disassemble the starter as shown at the beginning of this procedure.
3. Inspect the armature for wear or damage from contact with the permanent magnet. If there is wear or damage,
replace the armature.
Hide quick links:
Advertisement
Table of Contents
