Bosch STN150-18 Operating/Safety Instructions Manual page 13

BM 2610957389 04-09:BM STN150-18 06-09 6/17/09 7:45 AM Page 13
The No-Mar Pad on the nose of the work contact element
protects the work piece from the work contact element when
the work piece contact is compressed during actuation. The
pad can be removed and replaced, figure 17.
Disconnect the air supply from the tool
WARNING
!
and remove staples before removing or
replacing no-mar pads. Such precautionary safety
measures reduce the risk or unintentional tool operation.
To remove the pad: Pull the no mar tip directly away from
tool.
To replace the pad: Push the no mar tip on to the tool
inserting the opening of the no mar tip on to the work
contact element.
A correctly sized compressor is critical for maximum tool
performance. Use the following calculation to determine the
required compressor size.
Compressor size (CFM) =
x Shots per minute x Number of tools x 1.2
Air Consumption, one shot per second @ 100 psi: 1.8 CFM
Accessories
No-Mar Pad
Compressor
Air Consumption(CFM)
60
FIG. 17
Work Contact
Element
No-Mar Pad
13.