Liquiflo FTS Transfer Pump User Manual
Series No. FTS400
Transfer Pump Reassembly
Center plate disassembly, seal replacement, and reassembly
The center plate assembly contains four shaft seals, two sets of needle bearings, and two thrust washers. If your pump
has all Viton shaft seals, continue the instructions on this page. If your pump has Teflon shaft seals skip to page 31 for
seal installation instructions.
Replacing center plate outer seals
1. Using a Phillips #2 screwdriver, remove two retaining screws each on both thrust washers and remove the thrust
washers, Figure 1.
2. Using a seal removal tool, remove the center plate outer shaft seals hooking it under the lip of each seal and gently
prying upward, Figure 2.
3. Be sure you are using shaft seal number 1375-2000, Figure 3. If you purchased service kit #2, use the new shaft
seals. Position the shaft seals with the cup facing up, and push firmly into place.
4. Using a Phillips #2 screwdriver and two retaining screws each, install the two thrust washers, Figure 1.
Thrust
washer
screws
Figure 1
• Lubricate the inner lips of the shaft seals with Mobilgrease XHP
• Lightly pack the bearings with Mobilgrease XHP
4
Maintenance and service
The primary material of pump casing parts is
aluminum and fasteners are stainless steel.
Over tightening fasteners beyond the listed
torque specification can damage the
aluminum threads in pump parts.
™
222.
Seals
Figure 2
28
CAUTION
™
222.
Figure 3