TRAC-Vault BT • Surface Mount
Installation
Instructions
Introduction
TheTRAC-Vault BT is an intelligent storage device that
holds multiple keys or access cards and completely
documents access and recent use.
Recommended Hardware:
•
Four HECO MMS-SS 10 x 100 screws
Required Equipment:
•
Drill
•
Drill bits
•
Wrenches
•
Pliers or vice grips
You can order an installation kit from Supra that
contains all the necessary hardware for installing the
TRAC-Vault BT. An interior cover plate is also available.
TRAC-Vault BT Installation
Install the TRAC-Vault BT in a location convenient for
your keyholders. To meet ADA requirements, the unit
must be installed 48 inches from the ground to the
center of the device.
Important:
— Only masonry installation is approved for LPS 1175
certification. Through-the-wall installation method was
not tested to LPS 1175: Issue 7 SR2.
— Use four HECO MMS-SS 10x100mm masonry screws
or equivalent screws to maintain the LPS1175 security
certification.
— Never install masonry screws into mortar.
— When mounting on a rendered wall, the maximum
distance between the back of the keysafe and the
masonry substrate must be 10 mm.
— Do not mount TRAC-Vault BT closer than 6" or 15cm
to the corner of a masonry surface.
— Make sure TRAC-Vault BT is mounted flush with
masonry surface and the masonry screws are only
installed directly into brick.
— Minimize all gaps between back of TRAC-Vault BT
and masonry surface.
•
Level or punch
•
Pen or pencil
•
Dremel tool or
hacksaw
© 2013 UTC Fire & Security Americas Corporation, Inc.
Supra is a part of UTC Climate, Controls & Security.
Figure 1. Mounting holes
Four mounting
holes for 5/16"
bolts
Hole for tamper
switch wires
Drain hole
Figure 2. TRAC-Vault, side view
TRAC-Vault
TRAC-Lid BT
Lid chain
attachment
Vault
chain bracket
P/N 10103266P1 Rev C• January 2013
All rights reserved.
3
1
Tighten bolts in the
sequence indicated
by these numbers
4
2
Lock washer
Nut
Drain hole