Supra TRAC-Vault BT Installation Instructions

TRAC-Vault BT • Surface Mount
Installation Instructions
Introduction
TheTRAC-Vault BT is an intelligent storage device
that holds multiple keys or access cards and records a
comprehensive audit trail of who accessed it and when.
The following hardware is recommended for this
installation:
• Four HECO MMS-SS 10 x 100 screws
For best results, consult with a local fastener or
hardware store.
You can order an installation kit from Supra that contains
all the necessary hardware for installing the TRAC-Vault
BT. An interior cover plate is also available.
TRAC-Vault BT installation
Install the TRAC-Vault BT in a location convenient for
your keyholders. To meet ADA requirements, the unit
must be installed 48 inches from the ground to the
center of the device.
To install the TRAC-Vault BT, you will need the
following equipment:
• Drill
• Drill bits
• Wrenches
• Pliers or vice grips
• Level or punch
• Pen or pencil
• Dremel tool or hacksaw
To install the TRAC-Vault BT on a rendered wall:
1. Hold the vault in the desired postion on the wall,
being careful to locate the four mounting holes away
from mortar lines and away from the edge of the wall
as well as possible.
2. Using a marker, trace the location of all 4 mounting
holes.
3. Using a drill with an 8 mm masonry drill bit, drill each
hole to a depth of 105 mm. After drilling each hole,
© 2012 UTC Fire & Security. All rights reserved.
Figure 1. Mounting holes
Mounting holes
for 5/16" bolts
(4 places)
Hole for tamper
switch wires
Figure 2. TRAC-Vault, side view
TRAC-Vault
TRAC-Lid BT
Lid chain
attachment
Vault
chain bracket
ensure that each hole aligns with the 4 holes in the
back of the vault.
4. Clean out the debris from all 4 holes.
5. Insert one of the HECO mounting screws onto the
chain mounting bracket.
6. Place the TRAC-Vault up to the wall (drain hole
P/N 10103266P1 • August 2012
3
1
Tighten bolts in the sequence
indicated by these numbers
4
2
Drain hole
Lock washer
Nut
Drain hole