Table of Contents
Advertisement
Care and cleaning
Drainage pump
The pump can be accessed from inside the dishwasher.
1. Cut the power to the dishwasher by pulling out the
plug from the wall socket!
2. Remove the coarse filter and pipe section.
3. Remove the small yellow fitted piece at the left of the
bottom drain (see illustration below).
4. By inserting your finger into the hole you can turn the
pump blade to release anything blocking it.
5. Reinstall the fitted piece and filters.
6. Plug the machine in again.
If the dishwasher still does not start and a whirring
sound is heard, the overflow protection has been
activated.
•
Shut off the water.
•
Remove the plug from the wall socket.
•
Call the service division.
NOTE!
Do not forget to reinstall the fitted piece.
Lower spray arm
Holes and bearings can sometimes become blocked.
1. Pull the lower spray arm straight up to release it.
2. Remove any debris using a needle or the like. The
spray arms also have holes underneath.
Upper spray arm
The upper basket must be removed before the upper
spray arm can be released.
1. Pull out the upper basket and turn the basket catch
on each runner outwards (see illustration). The basket
can now be removed.
2. Loosen the upper spray arm in the same manner as
the lower spray arm and clean it.
23
Advertisement
Table of Contents
