Table of Contents
Advertisement
®
STERRAD
100S Installation Guide
1. Position the crate on a level surface so that the ramp side faces an
open area large enough for the ramp to be extended and the unit
removed.
2. Cut the banding and immediately dispose of it.
3. Using a screwdriver remove the two clips holding the ramp in place.
Note: The crate panels fit together with a tongue and
groove mechanism. The top must be lifted off
the sides and the sides must be lifted up from
the pallet base.
4. Slightly lift the top, then lift-up and lower the ramp.
5. Holding the Velcro straps, position the end of the ramp onto the crate
and fasten the Velcro tabs. Unfasten the support blocks from the
ramp.
6. Slide the nose ramp under the end of the main ramp.
Note: The middle support and the E-block support
are angled to fit the angle of the ramp.
7. Position the middle support under the center of the ramp and place
the E-block support at the top of the ramp near the crate.
8. Remove the remaining clips, the top, and the other three sides.
Remove the foam protectors.
9. Remove the box on top of the unit.
10. Remove the system panels and, using a 14 mm (9/16") deep socket
wrench, remove the hold-down bolts securing the machine to the
pallet. To remove the front bolt, slide the cassette storage drawer
forward in order to reach the bolt. Remove the water drain bottle to
reach the rear bolt. Remove the 4 x 4 block held in by the rear bolt.
11. Verify that the levelers in the front of the system are in the fully
retracted (up) position.
12. Drape the electrical cord next to the vacuum pump to keep it out of
the way.
Chapter 3. Installation
25
Advertisement
Table of Contents
