Related Manuals for Muir HR 700
Summary of Contents for Muir HR 700
- Page 1 T H E W O R L D P O W E R A N C H O R I N G S Y S T E M S HR 700 HFF 700 HORIZONTAL WINDLASS HR700-HFF700 12/01/2015 muir.com.au...
-
Page 2: Table Of Contents
11 Maintenance Schedule page 12 Drawings Deck Template (insert) Wiring Diagram for 12V DC two wire 200/600W motor (with solenoid) Exploded View of HFF 700 Exploded View of HR 700 Warranty and Warranty Registration Card page 18 HR700-HFF700 12/01/2015 muir.com.au... -
Page 3: Introduction
With Muir’s commitment to quality and use of superior materials and processes we know you will be... -
Page 4: Installation
2. From below, place washers and nut on each stud and tighten. NOTE: On assembly, grease all moving parts and deck plate grease nipple with Lithium/Teflon based grease. The Motor/gear drive assembly should be protected with anti-corrosion film or grease tape. HR700-HFF700 12/01/2015 muir.com.au... -
Page 5: Depth Of Chain Locker
Vertical windlasses minimise deck intrusion and the modern curved lines of the Muir windlass enhance the look of any vessel. A vertical windlass provides the advantages of a I 80-degree wrap of the anchor rode around the gypsy. -
Page 6: Handy Hints
The solenoid must not be installed in chain locker. It should be located in dry area only. For wiring information, please refer to the appropriate wiring diagram listed in the table below. This way up HR700-HFF700 12/01/2015 muir.com.au... -
Page 7: Wiring Layout
P O W E R A N C H O R I N G S Y S T E M S NOTE: ALL Free Fall models must include an isolating switch. NOT TO BE USED AS WIRING DIAGRAMS HR700-HFF700 12/01/2015 muir.com.au... -
Page 8: Operation
IT IS NECESSARY TO INSTALL AN ISOLATION SWITCH TO THE FREEFALL WINDLASSES TO SWITCH OFF THE WINCH WHEN NOT IN USE. This is to prevent the rope and chain from paying out if the winch is accidentally reversed HR700-HFF700 12/01/2015 muir.com.au... -
Page 9: Maintenance & Servicing
(P/N. P15PIN30415.88X41) from the gypsy, place Screwdriver (flat blade) into slot (E) and turn it a ¼ turn in the clockwise direction then hold. Now place3mm (1/8”) Allen key into (D) Grub screw and turn clockwise to tighten. HR700-HFF700 12/01/2015 muir.com.au... - Page 10 Line Care Using the wrong type of line may cause the line to jam and give excessive wear of the line. Muir Windlasses are designed to run on 3-strand nylon line (supplied by Muir) which has been specially treated with fabric softener to prevent it from hardening up.
-
Page 11: Trouble Shooting
If the line slips check the tension on the finger and increase spring tension. HYDRAULIC MOTOR Refer any problems with your hydraulic motor to a Muir service agent or Muir Hobart. FREEFALL MECHANISM Check that the freefall plunger and spring can move freely. -
Page 12: Maintenance Schedule
Maintenance & Servicing Remove chain wheel, clean cones then fully grease and lubricate. 3 years after installation see Maintenance & Servicing 4 years after installation Full winch Service HR700-HFF700 12/01/2015 muir.com.au... - Page 13 T H E W O R L D P O W E R A N C H O R I N G S Y S T E M S NOTES www.muir.com.au...
- Page 17 T H E W O R L D P O W E R A N C H O R I N G S Y S T E M S NOTES www.muir.com.au...
- Page 18 Normal worn parts or to damage caused by neglect, lack of maintenance, accident or improper service/installation or service by persons other than an authorised Muir representative. • Muir shall not be responsible for failures due to products being used in applications that they are not intended for, or exceed the products performance specifications. •...
- Page 19 T H E W O R L D P O W E R A N C H O R I N G S Y S T E M S NOTES www.muir.com.au...
- Page 20 WINDLASS SERIAL NUMBER © 2012 Muir Engineering Pty. Ltd. Muir reserves the right to alter specifications without notice. All rights reserved. While all due care and attention has been taken in the preparation of this manual no responsibility shall be taken for errors or omissions...
Need help?
Do you have a question about the HR 700 and is the answer not in the manual?
Questions and answers