Wire Routing Diagram; Upper Side View - Yamaha MX360 Supplementary Service Manual

WIRE ROUTING DIAGRAM

UPPER SIDE VIEW

1 Spark plug cap
2 TCI unit lead
3 Oil level switch lead
4 Oil warning unit
5 Engine switch
6 Engine switch lead (ground)
7 Wire harness protector
8 Oil warning light
A The spark plug cap should
face the direction indicated in
the illustration.
WIRE ROUTING DIAGRAM
B After passing the lead through,
lightly pull it in the direction of
the arrow. Make sure there is
no excessive slack in the lead
inside the fan case.
C Route the TCI unit lead as shown.
D The lead is black and the pro-
tector is gray.
E Pass through the leads to the
wire harness protector, and
then push into the oil warning
unit towards back.
4-12
SPEC
F Make sure that the gap
between the end of the wire
harness protector and end of
the crankcase is 5 mm (0.2 in)
or more.
G Fasten the ground terminal
and engine switch together.
H Insert the lead all the way in.
I Screw in the high tension cord
until it touches the spark plug
cap.